When you try our part of Cisco CCNA Routing and Switching 200-125 dumps, you can make a choice to our Passtcert. We will be 100% providing you convenience and guarantee. Remember that making you 100% pass Cisco certification 200-125 exam is Passtcert.What are you waiting for? Opportunity knocks but once. You can get CCNA Routing and Switching 200-125 complete as long as you enter Passtcert website.
The information of Passtcert can ensure you pass your first time to participate in the Cisco certification 200-125 exam.The curtain of life stage may be opened at any time, the key is that you are willing to show, or choose to avoid. Most of People who can seize the opportunityin front of them are successful. So you have to seize this opportunity of Passtcert. Only with it can you show your skills.
Share some CCNA Routing and Switching 200-125 exam questions and answers below.
What is the difference between a CSU/DSU and a modem?
A. A CSU/DSU converts analog signals from a router to a leased line; a modem converts analog signals from a router to a leased line.
B. A CSU/DSU converts analog signals from a router to a phone line; a modem converts digital signals from a router to a leased line.
C. A CSU/DSU converts digital signals from a router to a phone line; a modem converts analog signals from a router to a phone line.
D. A CSU/DSU converts digital signals from a router to a leased line; a modem converts digital signals from a router to a phone line.
Answer: D
Which two states are the port states when RSTP has converged?
(choose two)
A. blocking
B. learning
C. discarding
D. forwarding
E. listening
Answer: CD
Which two commands can be used to verify a trunk link configurationt status on a given cisco switch? (Choose two)
A. show interfaces interface
B. show interfaces trunk
C. show interfaces switchport
D. show ip interface brief
E. show interfaces vlan
Answer: BC
If a router has four interfaces and each interface is connected to four switches, how many broadcast domains are present on the router?
A. 1
B. 2
C. 4
D. 8
Answer: C
What are types of IPv6 static routes? (Choose Three.)
A. Recursive routes
B. Directly connected routes
C. Fully specified routes
D. Advertised routes
E. Virtual links
F. Redistributed routes
Answer: ABC
Which two statements about IPv6 and routing protocols are true? (Choose two.)
A. EIGRPv3 was developed to support IPv6 routing.
B. OSPFv3 was developed to support IPv6 routing.
C. Loopback addresses are used to form routing adjacencies.
D. EIGRP, OSPF, and BGP are the only routing protocols that support IPv6.
E. Link-local addresses are used to form routing adjacencies.
Answer: BE
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair network. From this statement, what is known about the network interface port?
A. This is a 10 Mb/s switch port.
B. This is a 100 Mb/s switch port.
C. This is an Ethernet port operating at half duplex.
D. This is an Ethernet port operating at full duplex.
E. This is a port on a network interface card in a PC.
Answer: C
Which set of commands is recommended to prevent the use of a hub in the access layer?
A. switch(config-if)#switchport mode trunk
switch(config-if)#switchport port-security maximum 1
B. switch(config-if)#switchport mode trunk
switch(config-if)#switchport port-security mac-address 1
C. switch(config-if)#switchport mode access
switch(config-if)#switchport port-security maximum 1
D. switch(config-if)#switchport mode access
switch(config-if)#switchport port-security mac-address 1
Answer: C
Passing Cisco certification 200-125 exam is not very simple. Perhaps passing Cisco certification 200-125 exam is a stepping stone to promote yourself in the IT area, but it doesn't need to spend a lot of time and effort to review the relevant knowledge, you can choose to use our Passtcert Cisco CCNA Routing and Switching 200-125 dumps prepared for the IT certification exams.